Sunfire L4-2.2L VIN F (2002)
1. Use a threaded stud in the hub to align the hub to the water pump sprocket.
2. Install the water pump.
3. Install the 2 bolts that secure the water pump to the engine block.
4. Install the feed pipe that joins the thermostat housing to the water pump.
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the engine front cover bolt (2) and the bolt (1) that secures the engine block to the water pump.
^
Tighten the bolts to 20 Nm (15 ft. lbs.).
6. Install 2 of the bolts that secure the water pump sprocket to the water pump.
7. Remove the threaded stud.
8. Install the last bolt.
^
Tighten the bolts to 10 Nm (89 inch lbs.).
