Sunfire L4-2.2L VIN F (2002)
10.
Remove the EN 45680-851 fixture and EN 45680-853 cylinder bore sleeve installer assembly (1) from the cylinder block (2).
Cylinder Liner Trimming
Note:
Do not bore or hone the cylinder bore sleeve. The cylinder bore sleeve inside diameter (I.D) is fully machined and honed to size and is
optimally finished as shipped. Any attempt to modify this factory-produced sizing and finish with additional boring and honing will lead to
engine damage, excessive noise or abnormal oil consumption.
1.
After installing the NEW cylinder bore sleeve(s) into the engine block, trim the excess material from the cylinder bore sleeve flange.