Sunfire L4-2.2L VIN F (2002)
7. Using care in order to prevent injury, strike the staking pin of the J 33019. Properly position the stake pin in the guide after each impact on the pin.
8. Continue to strike the pin of the J 33019 until a stake, similar to the original stake, is formed down to, but not touching, the bearing.
9. Stake 3 places 120 degrees apart.
10. With the compressor mounted to the J 34992, position the rotor and bearing assembly on the front head.
11. Position the J 33017 and the J 33023-A directly over the inner race of the bearing.
12. Position the J 8433-1 on the J 33023-A.
13. Assemble the 2 through bolts and the washers of the J 34992 through the slots of the J 8433-1.
14. Thread the 2 through bolts into the J 34992.
Ensure that the thread of the through bolts engages the full thickness of the J 34992.
15. Tighten the J 8433-3 in the J 8433-1 in order to force the pulley rotor and bearing assembly onto the front head of the compressor.
16. If the J 33017 slips off direct, in-line contact with inner face of the bearing, use the following steps:
16.1. Loosen the J 8433-3.
16.2. Realign the J 33017 and the J 33023-A in order to ensure that the installer clears the front head.
