Sunfire L4-2.2L VIN F (2002)
Center Mounted Brake Lamp: Service and Repair
Z24 Rear Spoiler
REMOVAL PROCEDURE
IMPORTANT: The high mounted stop lamp bulbs are not serviceable and the high mounted stop lamp must be replaced as a unit.
1. Open the rear compartment.
2. Disconnect the electrical connector from the high mounted stop lamp.
3. Remove the screws (1) from the high mounted stop lamp.
4. Remove the high mounted stop lamp from the rear spoiler, pulling the wiring harness from the rear compartment lid.
INSTALLATION PROCEDURE
1. Install the wiring harness to the rear compartment lid.
2. Install the high mounted stop lamp to the rear spoiler,
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the screws (1) to the high mounted stop lamp.
Tighten
Tighten the high mounted stop lamp screws to 2 N.m (18 lb in).
4. Connect the electrical connector to the high mounted stop lamp.
5. Close the rear compartment.
For a description of the RPO Code(s) shown in this article or any of the images therein, refer to the RPO Code List found at Vehicle/Application. See:
Application and ID/RPO Codes
