Sunfire L4-2.2L VIN F (2002)
Wheel Fastener: Service and Repair
Rear
Wheel Stud Replacement
Tools Required
^
J43631 Ball Joint Separator
Removal Procedure
1. Raise the vehicle on a hoist. Refer to Vehicle Lifting.
2. Remove the tire and the wheel assembly.
3. Remove the brake drum.
Notice: Do not hammer on brake drum as damage to the bearing could result.
4. Remove the wheel stud using the J43631.
5. Discard the wheel stud.
Installation Procedure
1. Install the new stud from the back side of the hub.
2. Install the four flat washers (1) on the hub.
3. Install the wheel nut (2) with the flat side toward the washers (1).
4. Tighten the nut (2) until the stud is properly seated in the hub flange.
5. Remove the nut (2) and the washers (1).
6. Install the brake drum.
7. Install the tire and the wheel assembly.
8. Lower the vehicle.