Sunfire L4-2.2L VIN F (2002)
Crankshaft Position Sensor: Service and Repair
Crankshaft Position (CKP) Sensor Replacement
REMOVAL PROCEDURE
1. Disconnect the battery.
2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle.
3. Remove the front air deflector, if applicable.
4. Remove the starter.
5. Disconnect the Crankshaft Position (CKP) sensor electrical connector.
6. Remove the CKP sensor bolt.
7. Remove the CKP sensor.
INSTALLATION PROCEDURE
1. Inspect the CKP sensor O-rings and lubricate with a mineral based grease.
2. Gentle insert the CKP sensor into the block.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the CKP sensor bolt.
Tighten
Tighten the CKP sensor bolt to 8 N.m (71 lb in).
4. Reconnect the CKP sensor electrical connector.
