Sunfire L4-2.2L VIN F (2002)
Band Apply Servo: Service and Repair
Low/Reverse Servo Assembly Replacement
Low/Reverse Servo Assembly Replacement
Removal Procedure
1. Remove the oil feed pipes.
2. Remove the 3 low and reverse band servo cover bolts, the servo and the spring.
3. Disassemble, clean and inspect the low and reverse servo assembly.
Installation Procedure
1. Assemble the low and reverse servo.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the lo and the reverse band servo cover bolts.
^
Tighten the bolts to 12 Nm (106 inch lbs.).
3. Install the oil feed pipe.