Sunfire L4-2.2L VIN F (2002)
Important: When installing a new park/lock cable, keep the shipping cover gauge attached until you are instructed to detach it. The shipping cover
gauge will aid in the proper positioning of the cable.
1. Ensure that the cable lock button is in the up position. Place the shift lever in the PARK position.
2. Snap the control cable connector into the automatic transmission control.
3. Place the ignition key in the RUN position.
Important: Do not insert the cable with the key in any position other than the RUN position.
4. Snap the control cable into the inhibitor housing until the snap lock is seated.
5. Remove the shipping cover gauge.
6. Turn the key to the LOCK position.
7. Snap the control cable end onto the shift park/lock lever pin.
8. Push the cable connector hose forward in order to remove any slack.
9. With no load applied to the connector nose, snap the cable connector lock button down.
