pontiac Workshop Repair Guides

Pontiac Workshop Service and Repair Manuals

Transmission Mount, A/T > < A/T - Fluid Oil Cooler Flush|Page 2702
Page 1
background image

Transmission Cooler: Technical Service Bulletins
Engine/Transmission - Oil Cooler Diagnosis

Number 84-6 (Gasoline)-19

Date 1/84

Subject:

ENGINE AND TRANSMISSION OIL COOLER DIAGNOSIS - 1983-1984 MODEL VEHICLES

When radiator oil coolers are suspected of leaking, they should be thoroughly checked before the radiator is removed for repair. This can be done by
testing the cooler with air pressure while the radiator is still in the car. BT-8316-A or J-34111 are Available Tools that can be used to test the oil coolers.

Testing

1.

Allow the engine to cool down.

2.

Disconnect the negative battery cable(s).

3.

Remove the radiator cap. Check coolant level in the radiator and add as necessary.

CAUTION:

Never remove the radiator cap on a warm engine. Removing the cap immediately lowers the boiling point of the liquid and can
cause violent overflow. The result could be a large coolant loss and possible personal injury.

4.

Place a drain pan under the car to catch lost oil.

5.

Disconnect the lower pipe or hose from the oil cooler to be tested.

6.

Disconnect the upper pipe or hose from the oil cooler. Install the correct adapter from the Tool Kit into the radiator oil cooler fitting.

7.

Apply 345 kPa (50 psi) adapter valve.

8.

Watch for bubbles in the coolant. If bubbles appear, remove radiator for repair.

9.

If no bubbles, increase the air pressure to 690 kPa (100 psi) and watch for bubbles. If still no bubbles, increase the air pressure to 1,034 kPa (150
psi) and again watch for bubbles.

If no bubbles appeared, the oil cooler is not leaking. If bubbles did appear, remove the radiator for repair.

10.

Reconnect the cooler lines (or hoses "O" rings) and torque to specifications.

11.

Connect the negative battery cable(s).

12.

Start the engine and check for leaks.

13.

Check and add coolant, engine oil or transmission fluid as necessary.

Engine Oil Cooler Diagnosis - UPC Number 062 375
Labor Operation:

T0124

Labor Time:

.5 hour (Diesel Engine Only)

Failure Code:

92

Transmission Oil Cooler Diagnosis - UPC Number 131 040
Labor Operation:

T0125

Labor Time:

.4 hour (Gas or Diesel Engine)

Failure Code:

92

Transmission Mount, A/T > < A/T - Fluid Oil Cooler Flush|Page 2702