Torrent AWD V6-3.4L VIN F (2006)
replaced, a thread locking chemical must be applied to the fastener threads. Failure to replace the fasteners or apply a thread-locking chemical
MAY reduce gasket sealing capability.
Notice: Refer to Fastener Notice in Service Precautions.
Important: All lower intake manifold bolts need to be clean, free of foreign materials, and reused only if new bolts are unavailable. Use GM P/N
1234382 (Canadian P/N 10953489) or equivalent and apply to the old intake manifold bolt threads.
Important: Manufacturer recommends the center bolts be fully torqued before the diagonal bolts to assure proper torque distribution.
Important: Lower intake manifold bolts in locations (6) and (7) should be torqued to specification using a crows foot type tool.
Install the lower intake manifold bolts.
1. On the first pass. Tighten the lower intake manifold bolts (1, 2, 3, 4) in sequence to 7 Nm (62 inch lbs.).
2. On the final pass. Tighten the lower intake manifold bolts (1, 2, 3, 4) in sequence to 13 Nm (115 inch lbs.).
3. On the final pass. Tighten the lower intake manifold bolts (5, 6, 7, 8) in sequence to 25 Nm (18 ft. lbs.).
7. Install the fuel rail assembly.
8. Connect the radiator inlet hose to the thermostat housing.
9. Install the heater inlet pipe.
10. Install the upper intake manifold.
11. Fill the cooling system.
