pontiac Workshop Repair Guides

Pontiac Workshop Service and Repair Manuals

SIR Disabling and Enabling Zones|Page 2787 > < SIR Disabling and Enabling Zones|Page 2785
Page 11
background image

2. Connect the I/P module connector to the vehicle harness connector.
3. Install the CPA to the I/P module connector.

4. Install the AIR BAG fuse into the body control module fuse center.
5. Install the body control module fuse center cover.
6. Use caution while reaching in and turn the ignition switch to the ON position.The AIR BAG indicator will flash then turn OFF.
7. Perform the SIR Diagnostic System Check if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check -

Vehicle in Vehicle DTC Information.

SIR Disabling and Enabling Zone 6

SIR DISABLING AND ENABLING ZONE 6

DISABLING PROCEDURE

1. Turn the steering wheel so that the vehicles wheels are pointing straight ahead.
2. Turn the ignition switch to the OFF position.
3. Remove the key from the ignition switch.
4. Locate the body control module fuse center. Remove the fuse center cover.

SIR Disabling and Enabling Zones|Page 2787 > < SIR Disabling and Enabling Zones|Page 2785