Torrent AWD V6-3.4L VIN F (2006)
Data Link Connector: Service and Repair
DATA LINK CONNECTOR REPLACEMENT
REMOVAL PROCEDURE
1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 8.
CAUTION:
-
Do not strike or jolt the inflatable restraint sensing and diagnostic module (SDM). Before applying power to the SDM, make sure that it is
securely fastened with the arrow facing toward the front of the vehicle. Failure to observe the correct installation procedure could cause
SIR deployment, personal injury, or unnecessary SIR system repairs.
-
If the vehicle interior is exposed to moisture and becomes soaked up to the level of the sensing and diagnostic module (SDM), the SDM
and SDM harness connector must be replaced. The SDM could be activated when powered, which could cause airbag deployment and
result in personal injury.
2. Remove the console assembly.
3. Remove the retainers from the connector position assurance (CPA) and disconnect the electrical connectors.
4. Remove the nuts and remove the SDM.
INSTALLATION PROCEDURE
1. Remove any dirt, grease, or other contaminants from the mounting surface.
2. Install the SDM to the vehicle with the nuts.
Tighten the nuts to 10 N.m (89 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the console assembly.
