Torrent AWD V6-3.4L VIN F (2006)
Air Bag Control Module: Service and Repair
INFLATABLE RESTRAINT SENSING AND DIAGNOSTIC MODULE REPLACEMENT
REMOVAL PROCEDURE
1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 8.
CAUTION: Do not strike or jolt the inflatable restraint sensing and diagnostic module (SDM). Before applying power to the SDM, make
sure that it is securely fastened with the arrow facing toward the front of the vehicle. Failure to observe the correct installation procedure
could cause SIR deployment, personal injury, or unnecessary SIR system repairs.
2. Remove the console assembly.
3. Remove the retainers from the connector position assurance (CPA) and disconnect the electrical connectors.
4. Remove the nuts and remove the sensing and diagnostic module (SDM).
INSTALLATION PROCEDURE
1. Remove any dirt, grease, or other contaminants from the mounting surface.
2. Install the SDM to the vehicle with the nuts.
Tighten the nuts to 10 N.m (89 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the console assembly.
4. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 8.
5. Reprogram the BCM. Refer to Body Control Module (BCM) Programming/RPO Configuration in Computer/Integrating Systems.
IMPORTANT: If you do NOT perform the BCM programming procedure, the vehicle option content information which is read by the BCM may be
