pontiac Workshop Repair Guides

Pontiac Workshop Service and Repair Manuals

Ignition - Ignition Lock Cylinder is Hard To Turn/Binds|Page 10798 > < Wheel Speed Sensor Replacement - Front|Page 10786
Page 1
background image

Ignition Switch Lock Cylinder: Customer Interest
Ignition - Ignition Lock Cylinder is Hard To Turn/Binds

Bulletin No.: 06-02-35-016C

Date: October 02, 2007

TECHNICAL

Subject:
Ignition Lock Cylinder is Hard to Turn or Binds (Clean and Lubricate Ignition Lock Cylinder/Housing)

Models:
2005-2006 Chevrolet Equinox
2006 Pontiac Torrent
2003-2007 Saturn VUE

Supercede:

This bulletin is being revised to update the lubrication information by adding steps and photos. Please discard Corporate Bulletin Number
06-02-35-016B (Section 02 - Steering Wheel and Column).

Condition

Some customers may comment that the ignition lock cylinder intermittently sticks or binds.

Cause

A lack of lubrication may cause adjoining metal surfaces to wear, resulting in a significant amount of powder (black in color) to form in the ignition
cylinder case housing.

Correction

If the following lubrication procedure was already performed on this vehicle, contact Technical Assistance (TAC).

Remove the ignition lock cylinder, clean the ignition lock cylinder and case housing. Then lubricate the ignition lock cylinder tip and case using the
procedure below.

You must use two different GM lubricants as outlined in this procedure.

Remove the battery cover and disconnect the negative battery cable.

Remove the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement in SI.

Tip

Use a shop cloth wrapped around a screwdriver to aid in cleaning the inside of the ignition case housing (1).

Wet a shop cloth with GM Brake Cleaner, P/N 12378392 (in Canada, 88901247), or equivalent and wipe out the inside of the ignition cylinder case

Ignition - Ignition Lock Cylinder is Hard To Turn/Binds|Page 10798 > < Wheel Speed Sensor Replacement - Front|Page 10786