Torrent AWD V6-3.4L VIN F (2006)
8. Install the large clamp over the large diameter of the seal.
9. Install the tripot housing to the tripot spider assembly on the wheel drive shaft bar.
10. Slide the large diameter of the seal over the outside of the tripot housing and position the lip of the seal in the housing groove.
11. Place the large seal retaining clamp around the seal and close using J 35910 .
12. Inspect the gap dimension on the clamp ear. Continue tightening until the gap dimension is reached.
Dimension equals 1.9 mm (5/64 inch).
13. Rotate the housing in a circular motion to distribute the grease in the tripot joint.
Wheel Drive Shaft Inner Joint and Seal Replacement - Rear
Wheel Drive Shaft Inner Joint and Seal Replacement - Rear
^
Tools Required
-
J 35910 Drive Axle Seal Clamp Pliers
Disassembly Procedure
