Torrent AWD V6-3.6L (2008)
4. Position the fuel fill tube to the closeout grommet (1).
Notice: Refer to Fastener Notice.
5. Install the fuel fill tube bracket bolts (2).
Tighten the bolt to 12 N.m (106 lb in).
Important: Ensure that the fuel fill tube connecting hose is installed until it touches the fuel tank body. The hose clamp should be located
within 13 mm (1/2 in) of the end of the connecting hose.
6. Position the fill tube-to-fuel tank connecting hose and hose clamp.
Tighten the clamp to 5 N.m (44 lb in).
7. Connect the fuel fill vent tube and fresh air hose.
8. Install the inner wheelhouse liner.
9. Install the wheel and tire.
10. Lower the vehicle from the hoist.
11. Install the fuel fill cap.
12. Perform the Service Bay Diagnostic Test for the EVAP emission system using the scan tool. This test will verify the integrity of the vapor handling
areas of the fuel system.
13. Install the fuel injector sight shield.
