pontiac Workshop Repair Guides

Pontiac Workshop Service and Repair Manuals

Engine Controls - MIL/SES Lamp ON/DTC P2610 Stored|Page 9663 > < Engine/Transmission - Aftermarket Calibrations|Page 9658
Page 1
background image

PROM - Programmable Read Only Memory: All Technical Service Bulletins
Engine Controls - MIL/SES Lamp ON/DTC P2610 Stored

Bulletin No.: 07-06-04-035

Date: December 18, 2007

TECHNICAL

Subject:
3.6L LY7 Engine - MIL/SES Light Illuminated, DTC P2610 Stored (Reprogram ECM)

Models:
2008 Cadillac CTS, SRX
2008 Chevrolet Equinox
2008 Pontiac Torrent

with 3.6L VVT V6 Engine (VIN 7 - RPO LY7)

Built Prior to the VIN Breakpoints shown.

Condition

Some customers may comment that the MIL/SES light is illuminated.

Upon further investigation, technicians may find Diagnostic Trouble Code (DTC) P2610 - Control Module Ignition Off Timer Performance stored.

Cause

Engineering has identified a concern with the ECM software that may cause this condition.

Correction

DO NOT replace the ECM for this condition.

If DTC P2610 has set, reprogram the ECM with the latest calibration.

Refer to Service Programming System (SPS) using the appropriate Service Information (SI) procedures. Do not attempt to order the calibration number
from GMSPO. The calibration numbers required for this service procedure are programmed into control modules via a Techline Tech 2(R) scan tool and
the Techline Information System (TIS) 2000 terminal with the calibration update.

Use data version 8.5 for 2007 or later, available on TIS 2 Web 08/19/07; and on TIS DVD version 9.0/2007 or later, mailed to dealers beginning
09/12/07. As always, make sure your Tech 2(R) is updated with the latest software version. If you cannot access the calibration, call the Techline
Customer Support Center.

Warranty Information

Engine Controls - MIL/SES Lamp ON/DTC P2610 Stored|Page 9663 > < Engine/Transmission - Aftermarket Calibrations|Page 9658