Torrent AWD V6-3.6L (2008)
7. Install a new cotter pin.
8. Install the outer tie rod end to the knuckle. Refer to Rack and Pinion Outer Tie Rod End Replacement (See: Steering/Tie Rod/Tie Rod
End/Service and Repair) .
Important: Do not allow the stabilizer link ball stud to rotate while installing the link nut.
9. Position the stabilizer shaft link to the strut assembly and install the nut.
Tighten the nut to 65 N.m (48 lb ft).
10. Install the wheel bearing/hub assembly. Refer to Front Wheel Bearing and Hub Replacement (See: Wheel Bearing/Service and Repair/Front
Suspension) .
11. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Wheels and Tires/Service and Repair) .
12. Lower the vehicle.
13. Perform a wheel alignment. Refer to Wheel Alignment Measurement (See: Alignment/Service and Repair/Wheel Alignment Measurement) .