Torrent FWD V6-3.4L (2007)
Notice: The inertial weight section of the crankshaft balancer is assembled to the hub with a rubber type material. The correct installation
procedures (with the proper tool) must be followed or movement of the inertial weight section of the hub will destroy the tuning of the crankshaft
balancer.
Notice: Do NOT use a power-assisted tool with the special tool in order to remove or install this component. You cannot properly control the
alignment of this component using a power-assisted tool, and this can damage the component.
9. Remove the crankshaft balancer using the J 41816-A along with EN 46359 .
Installation Procedure
1. Apply sealer GM P/N 12378521 (Canadian P/N 88901148) or the equivalent, to the keyway of the crankshaft balancer.
2. Place the crankshaft balancer into position over the key in the crankshaft.
Notice: Do NOT use a power-assisted tool with the special tool in order to remove or install this component. You cannot properly control the
alignment of this component using a power-assisted tool, and this can damage the component.
3. Install the J 29113 onto the crankshaft.
4. Rotate the hex nut on the J 29113 to install the crankshaft balancer onto the crankshaft.
5. Remove the J 29113 from the crankshaft .
