Torrent FWD V6-3.4L (2007)
3. Loosen the rear mount through bolt. Do not remove.
4. Shake the powertrain vigorously from front to rear and allow the powertrain to settle.
Notice: Refer to Fastener Notice .
5. Tighten the rear motor mount through bolt.
Tighten the bolt to 110 N.m (81 lb ft).
6. Tighten the front motor mount through bolt.
Tighten the bolt to 110 N.m (81 lb ft).
7. Lower the vehicle.
Powertrain Mount Balance - Total Mounts
Powertrain Mount Balance - Total Mounts
Important: Follow the balance procedure in the order listed in the following steps. Powertrain mounts must be tightened in sequence.
1. Raise and support the vehicle.
2. Position two floor jacks with wood blocks under the engine and transmission to support the powertrain assembly.
