Torrent FWD V6-3.4L (2007)
Evaporative Emissions Hose: Service and Repair
Evaporative Emission (EVAP) Hoses/Pipes Replacement - Engine/Chassis
EVAPORATIVE EMISSION HOSES/PIPES REPLACEMENT - ENGINE/CHASSIS
REMOVAL PROCEDURE
CAUTION:
-
Do not allow smoking or the use of open flames in the area where work on the fuel or EVAP system is taking place. Anytime work is
being done on the fuel system, disconnect the negative battery cable, except for those tests where battery voltage is required.
-
Whenever fuel lines are removed, catch fuel in an approved container. Container opening must be a minimum of 300 mm (12 in)
diameter to adequately catch the fluid.
NOTE: Fuel/Vapor lines cannot be spliced or repaired. The line must be replaced (if damaged) with the same type of line.
1. Disconnect the engine evaporative emission (EVAP) purge hose/pipe from the chassis EVAP purge hose/pipe.
2. Cap or plug both the engine and chassis EVAP purge hose/pipes to prevent contamination.
3. Raise and support the vehicle. Refer to Vehicle Lifting.
4. Disconnect the EVAP purge hose/pipe from the EVAP canister.
5. Cap or plug both the EVAP purge hose/pipe and canister to prevent contamination.
