Torrent FWD V6-3.4L (2007)
Fluid - A/T: Service and Repair
Transaxle Fluid Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the drain plug and drain fluid. Allow at least 5 minutes for the fluid to drain completely.
3. Remove the gasket from the drain plug and discard.
Installation Procedure
1. Install the new gasket on the drain plug.
Notice: Refer to Component Fastener Tightening Notice.
2. Install the drain plug.
Tighten the drain plug to 40 N.m (30 lb ft).
3. Make sure vehicle is level.
4. Remove the fluid level indicator located behind the front transaxle mount.
Notice: Do not remove the 3rd gear anchor band bolt located on top of the transmission for checking fluid or adding fluid. Removing the bolt will
dislocate internal components and require the transmission to be removed from the vehicle and disassembled for repair.
Important: Dexron(R)III automatic transmission fluid is not compatible with this transaxle. If Dexron(R)III ATF is used, transaxle
failure will result. Refer to Sealers, Adhesives, and Lubricants.
5. Add approximately 3.1 L (3.3 Qt) of GM T-IV fluid to the transaxle, using the fluid level indicator location.
