pontiac Workshop Repair Guides

Pontiac Workshop Service and Repair Manuals

Symptom Related Diagnostic Procedures|Page 17124 > < Symptom Related Diagnostic Procedures
Page 2
background image

1. Ignition OFF, disconnect the REAR DEFOG relay.
2. Test for 60-180 ohms of resistance between terminals 85 and 86.

-

If the resistance is not within the specified range, replace the relay.

3. Test for infinite resistance between the following terminals:

-

30 and 86

-

30 and 87

-

30 and 85

-

85 and 87

-

If not the specified value, replace the relay.

4. Install a 25-amp fused jumper wire between relay terminal 85 and 12 volts. Install a jumper wire between relay terminal 86 and ground. Test for 

less than 2 ohms of resistance between terminals 30 and 87.
-

If greater than the specified range, replace the relay.

REPAIR INSTRUCTIONS

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
-

Body Control Module Replacement

-

HVAC Control Module Replacement

-

Liftgate Window Replacement

-

Relay Replacement (Attached to Wire Harness) Relay Replacement (Within an Electrical Center)  See: Powertrain Management/Computers and
Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests and Procedures

Symptom Related Diagnostic Procedures|Page 17124 > < Symptom Related Diagnostic Procedures