Torrent FWD V6-3.4L (2007)
Use of an alternative method of urethane application "bead applied to body", may be used as required/needed.
Notice:
At no time should the applied urethane exceed 5 minutes prior to glass installation.
2.
Install the glass to the vehicle within 5 minutes of the urethane application.
3.
If the 5 minute limit is exceeded, scrape/remove the urethane and reapply a new bead.
4.
Upon installation, check the left / right positioning (centering) and lightly press the glass into position.
5.
Position the glass to ensure that the rear edge of the upper reveal molding does not gap to the roof surface, by shifting the windshield upward.
6.
Apply masking tape to hold the glass in place during the urethane cure. Use a tape that will not leave adhesive residue on the vehicle upon
removal.
7.
Clean any excess urethane adhesive on the show surfaces by wiping immediately with a paint shop quality rag dampened with the glass bonding
adhesive manufacturer's recommended cleaning solvent.
8.
Remove the masking tape after two hours.
Service Procedure
1.
Remove the windshield, liftgate window, and quarter windows from the vehicle. Refer to Windshield Replacement, Quarter Window Replacement,
and Liftgate Window Replacement in SI for window removal instructions.
2.
Replace the windshield, liftgate window, and quarter windows. Refer to Windshield Replacement, Quarter Window Replacement, and Liftgate
Window Replacement in SI for window installation instructions.
