pontiac Workshop Repair Guides

Pontiac Workshop Service and Repair Manuals

Fluid - A/T|Capacity Specifications|Page 774 > < Fluid - A/T|Capacity Specifications|Page 772
Page 1
background image

Fluid - A/T: Testing and Inspection

Fig. 2  Transaxle Dipstrick Oil Level Readings

    The transmission oil level should be approximately 1/2 inch above the ``FULL'' mark at room temperature (65°-85°F), or between the two dimples on
the dipstick, Fig. 2. The oil level at normal operating temperature (190°-200°F) should be between the ``ADD'' and ``FULL'' marks. The vehicle must be
driven at least 15 minutes to allow the transmission oil to reach normal operating temperature. To bring the oil level from the ADD mark to the FULL
mark requires approximately one pint of fluid. Check oil level with vehicle on level surface, parking brake applied, engine idling at operating
temperature and transmission in Park.
    If additional fluid is required, use only Dexron II or Dexron IIE automatic transmission fluid. When adding fluid, do not overfill, as foaming and
loss of fluid through the vent may occur as the fluid heats up. Also, if fluid level is too low, complete loss of drive may occur especially when
cold, which can cause transmission failure.

Fluid - A/T|Capacity Specifications|Page 774 > < Fluid - A/T|Capacity Specifications|Page 772