Trans Sport V6-3800 3.8L (1994)
2. When installing an old switch, proceed as follows:
a. Assemble mounting bolts-to-case, loosely, then insert a 3/32 inch maximum diameter gauge pin in service adjustment hole.
b. Rotate switch until pin drops in to a depth of 1/8 inch.
c. Install retaining bolts and nut, then connect electrical connector.
3. When installing new switch proceed as follows:
a. Install mounting bolts and tighten. If bolt holes do not align with mounting boss on transaxle, ensure shift shaft is in Neutral. Do not rotate
switch. Switch is pinned in Neutral position.
b. If switch has been rotated and pin broken, install switch as outlined in Step 2.
4. After switch installation, verify that engine will only start in Park and Neutral positions. If engine starts in any other position, adjust switch as
follows:
a. Place transaxle control shifter assembly in the Neutral notch in the detent plate.
b. Loosen switch attaching screws and nut.
c. Rotate switch on shifter assembly to align service adjustment hole with carrier tang hole.
d. Insert a 3/32 maximum diameter gauge pin to a depth of 5/8 inch.
e. Tighten attaching screws and nut.
f.
Remove gauge pin.
