Vibe L4-1.8L (2008)
Emergency Contact Module: Service and Repair
OnStar Module Bracket Assembly Replacement
OnStar Module Bracket Assembly Replacement
Removal Procedure
1. Remove the communication interface module. Refer to Communication Interface Module Replacement (See: Communications Control
Module/Service and Repair).
2. Remove the communication vehicle interface unit. Refer to OnStar Vehicle Interface Unit Replacement (See: OnStar Vehicle Interface Unit
Replacement).
3. Unclip the antenna and module harness (1), from the module bracket.
4. Disconnect the inverter electrical connector (2).
5. Remove 3 module bracket mounting bolts.
6. Remove the module bracket.
Installation Procedure
