Vibe L4-1.8L VIN L (2003)
Installation Procedure
1. Lubricate the insides of 2 NEW boots (15,20) with wheel bearing lubricant, GM P/N 1051344 (Canadian P/N 993037), or an equivalent lithium
soap base glycol lubricant.
2
Use a 19 mm socket and a hammer in order to install the boots to the bracket (14). Verity the boots are firmly on the bracket.
3. Lubricate the sliding pins (17,21) with wheel bearing lubricant, GM P/N 1051344 (Canadian P/N 993037), or an equivalent lithium soap base
glycol lubricant.
4. Install the sliding pin without the sliding bushing to the upper position in the bracket.
5. Install the sliding pin with the sliding bushing to the lower position in the bracket.
6. Install the upper brake pad retainer (4) to the caliper bracket.
7. Install the lower brake pad retainer (9) to the caliper bracket.
8. Install a new inner wear indicator (3) to the inner pad (10).
9. Install a new outer wear indicator (5), if equipped, to the outer pad (6).
10. Apply disc brake insulator silicone lubricant, GM P/N 1801908, or an equivalent lubricant, to both sides of a new inner pad insulator (2).
11. Install the inner pad insulator to the inner pad.
12. Install a new inner insulator (1) to the inner pad insulator.
13. Apply disc brake insulator silicone lubricant, GM P/N 1801908, or an equivalent lubricant, to both sides of a new outer pad insulator (8).
14. Install the outer pad insulator to the outer pad.
15. Install a new outer insulator (7) to the outer pad insulator.
16. Install the brake pads. Refer to Brake Pads Replacement - Front.
Disc Brake Hardware Replacement - Rear
Disc Brake Hardware Replacement - Rear
Removal Procedure
