Vibe L4-1.8L VIN L (2003)
Receiver Dryer: Service and Repair
RECEIVER DEHYDRATOR REPLACEMENT
REMOVAL PROCEDURE
1. Discharge and recover the refrigerant. Refer to Refrigerant Recovery and Recharging.
2. Remove the pressure switch (3) from the receiver (6).
3. Remove the bolt (4) and liquid tube from the receiver.
4. Remove the bolt (5) and tube from the condenser.
5. Remove the 2 screws (7) from the receiver.
6. Remove the receiver from the vehicle.
INSTALLATION PROCEDURE
IMPORTANT: Add 40 ml (1.3 fl oz) of refrigerant oil to the refrigeration system when installing a new condenser dryer.
1. Position the receiver into the vehicle.
2. Install the receiver (6) to the condenser. Install the 2 screws (7).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the tube to the condenser. Secure with the bolt (5).
Tighten
Tighten the bolt (5) to 5.4 N.m (48 lb in).
