Vibe L4-1.8L VIN L (2003)
Wheel Bearing: Service and Repair
Rear Suspension
Wheel Bearing/Hub Replacement Rear (FWD)
Removal Procedure
1. If the vehicle has rear disc brakes, remove the rear brake rotor.
2. If the vehicle has rear drum brakes, remove the brake drum.
3. If the vehicle has ABS, disconnect the rear wheel speed sensor connector (3). Position the connector to the side.
4. Remove the 4 bolts (1, 2, 4, 5).
5. Remove the wheel bearing and hub assembly.
Installation Procedure
Notice:
Refer to Fastener Notice in Service Precautions.
See: Steering and Suspension/Service Precautions/Vehicle Damage Warnings/Fastener Notice
1. Install the wheel bearing and hub assembly and the 4 bolts (1, 2, 4, 5).
Tighten the bolts to 61 Nm (45.0 ft. lbs.).
2. Connect the rear wheel speed sensor connector (3).
3. If the vehicle has rear drum brakes, install the brake drum,
4. If the vehicle has rear disc brakes, install the rear brake rotor.
5. Perform the Diagnostic System Check - ABS. See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and
Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System Check