Vibe L4-1.8L VIN L (2003)
39. Twist together 1 end of each wire on the passenger side air bag deployment harness in order to short the wires.
40. Remove the drop cloth from the vehicle.
41. Disconnect both harnesses from the vehicle.
42. Discard the harnesses.
43. Scrap the vehicle in the same manner as a non-SIR equipped vehicle.
44. If 1 or both of the modules did not deploy, perform the following steps:
44.1. Remove the undeployed module(s) from the vehicle.
44.2. Temporarily store the module(s).
44.3. Call the Technical Assistance Group for further assistance.
Handling A Deployed Inflator Module
After the inflator module has deployed, the surface of the air bag may contain a powdery residue. This powder consists primarily of cornstarch, used to
lubricate the bag as it inflates, and by-products of the chemical reaction. The deployment reaction produces sodium hydroxide dust, similar to lye soap.
The sodium hydroxide quickly reacts with the atmospheric moisture. This atmospheric moisture converts the sodium hydroxide into sodium carbonate
and sodium bicarbonate, baking soda. Therefore, you will probably find no sodium hydroxide present after the deployment. Gloves and safety glasses are
recommended, however, as a precaution. Gloves and safety glasses help to prevent possible irritation of the skin or eyes.
