Vibe L4-1.8L VIN L (2003)
5. Remove the manual lever.
6. Align the groove (1) with the neutral base line (2).
7. Hold the switch in position, then tighten the 2 bolts.
^
Tighten the Park/Neutral Position (PNP) switch bolts to 5.5 Nm (49 inch lbs.).
8. Stake the lock plate over the manual shaft nut.
9. Install the manual lever onto the manual shaft. Secure the manual lever with 1 lock washer and nut.
^
Tighten the manual lever nut to 12.5 Nm (9 ft. lbs.).
10. Install the PNP shift electrical connector to the PNP switch.
11. Install the shift select cable and nut to the manual lever.
^
Tighten the shift cable retaining nut to 12.5 Nm (9 ft. lbs.).
12. Install the shift select cable in the retaining bracket (2), then install the clip (3).
13. Install the battery tray in the vehicle, then the 4 battery tray retaining bolts.
^
Tighten the bolts to 13 Nm (10 ft. lbs.).
