Vibe L4-1.8L VIN L (2003)
Tighten the bolt to 157 Nm (115.8 ft. lbs.).
16. Tighten the bolt (15).
Tighten the bolt to 113 Nm (83.3 ft. lbs.).
17. Insert the dowel into the hole in the left side of the crossmember and the hole in the body.
18. Use the dowel in order to align the bolt holes.
19. Tighten the bolt (8).
Tighten the bolt to 157 Nm (115.8 ft. lbs.).
20. Tighten the bolt (6).
Tighten the bolt to 113 Nm (83.3 ft. lbs.).
21. Remove the jack from the crossmember.
22. Install the 3 nuts (9, 10, 11).
Tighten the nuts to 52 Nm (38.4 ft. lbs.).
23. Install the 5 bolts (1, 2, 3, 4, 5).
Tighten the bolts to 52 Nm (38.4 ft. lbs.).
24. If you are installing the crossmember WITHOUT the steering gear, complete the following steps:
24.1.
Install the 4 bolts (7, 12, 13, 14).
Tighten the bolts to 58 Nm (42.8 ft. lbs.).
24.2.
Remove the wire from the steering gear (11).
25. Install the following to the left front control arm:
-
The 2 nuts (1, 2)
-
The bolt (3)
Tighten the 2 nuts and the bolt to 89 Nm (65.6 ft. lbs.).
