Vibe L4-1.8L VIN L (2003)
Transmission Speed Sensor: Service and Repair
MU4
Vehicle Speed Sensor (VSS) Replacement
^
Tools Required
-
J 36350 Transmission Assembly Lubricant
Removal Procedure
Caution: Refer to Battery Disconnect Caution in Service Precautions.
1. Disconnect the negative (-) battery cable.
2. Disconnect the Vehicle Speed Sensor (VSS) electrical connector.
3. Remove the 1 retaining bolt (1) anal the VSS (2) from the transaxle.
4. Inspect the VSS O-ring for cuts or damage. Replace as necessary.
Installation Procedure
1. Apply J 36350 to the VSS O-ring.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the Vehicle Speed Sensor (VSS) into the transaxle case. Secure the VSS (2) with the retaining bolt (1).
^
Tighten the VSS speed sensor (VSS) bolt to 6 Nm (53 inch lbs.).
3. Connect the VSS electrical connector.
4. Connect the negative (-) battery cable.