Vibe L4-1.8L VIN L (2003)
1. Install the sliding yoke (1) into the transmission with the two piece propeller shaft assembly.
2. Ensure that the sliding yoke splines are lubricated.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the mid shaft bearing support bolts (1, 2).
^
Tighten the bolts to 37 Nm (27 ft. lbs.).
4. Install the pinion flange yoke to the differential pinion flange with the reference marks. Secure the pinion flange yoke with 4 bolts and 4 nuts and
washers.
^
Tighten the propeller shaft bolts and nuts to 74 Nm (54 ft. lbs.).
5. Lower the vehicle.