Vibe L4-1.8L VIN L (2003)
7. Install a new retaining ring to the axle shaft.
8. Insert the remaining grease from the service kit into the boot.
9. Install the boots into the shaft grooves.
10. Ensure that the drive shaft is at standard length.
^
The standard length is approximately 688.33 - 698.33 mm (27.098 - 27.492 inch).
11. Position the small boot retaining clamp onto the neck of the boot.
12. Position the and small retaining clamp to the axle shaft.
Notice: Refer to Fastener Notice in Service Precautions.
13. Using the J 42572, crimp the small boot retaining clamp.
14. Position the large boot retaining clamp onto the boot.
15. Position the boot and large retaining clamp to the joint outer race.
Important: The boot must not be dimpled, stretched or out of shape in any way.
