Vibe L4-1.8L VIN L (2003)
16. Inspect the boot for proper shape.
If the boot is NOT shaped correctly, equalize the pressure in the boot by lifting the boot edge slightly and shape the boot properly by hand.
17. Inspect the boot for damage.
If the boot has been cut or punctured during assembly, you must discard and replace the boot.
Important: The boot retaining clamp must not be over-tightened or under-tightened.
18. Using the J 42572, crimp the large boot retaining clamp.
19. Inspect the outer CV joint and wheel drive shaft for smooth operation. This will also distribute the grease within the joint.
19.1.
Hold the wheel drive shaft vertically, with the outer joint at the bottom.
19.2.
Rotate the wheel drive shaft 4 or 5 times in a circular motion.
