Vibe L4-1.8L VIN L (2003)
Quarter Window Glass: Service and Repair
Quarter Window Replacement
Tools Required
*
J 24402-A Glass Cold Knife Sealant Remover
*
J 39032 Stationary Glass Removal Tool
*
Urethane Adhesive Kit GM P/N 12346284 (Canadian P/N 10952983) or Equivalent
*
Isopropyl Alcohol or Equivalent
*
Cartridge-type Caulking Gun
*
Commercial-type Utility Knife
*
Razor Blade Scraper
*
Suction Cups
*
Plastic Paddle
Removal Procedure
1. Remove the upper quarter trim panel. Refer to Trim Panel Replacement - Rear Quarter Upper (See: Body and Frame/Interior Moulding /
Trim/Trim Panel/Service and Repair/Trim Panel Replacement - Rear Quarter Upper) in Interior Trim.
Caution: If a window is cracked but still intact, crisscross the window with masking tape in order to reduce the risk of damage or personal injury.
Caution: If broken glass falls into the defroster outlets, it can be blown into the passenger compartment and cause personal injury.
Important: Before cutting out a quarter window, apply a double layer of masking tape around the perimeter of the painted surfaces and
the interior trim.
2. Cover to protect the following parts from broken glass:
1. Upper dash pad
2. Defroster outlets and A/C outlets
3. Seats and carpeting
Caution: Refer to Glass and Sheet Metal Handling Caution in Cautions and Notices.
Important: Keep the cutting edge of the tool against the window.
3. This will allow the urethane adhesive to be separated from the window.
*
Leave a base of urethane on the pinchweld flange.
*
The only suitable lubrication is clear water.
*
Use J24402-A ,J 39032 or equivalent in order to remove the window.
