Vibe FWD L4-1.8L (2010)
Body Emblem: Service and Repair
Exterior Trim Molding/Nameplate Replacement
Exterior Trim Molding/Nameplate Replacement
Tools Required
J 41409 Body Molding Removal Tool
Removal Procedure
1. The following components are attached to the body panels with adhesive tape:
*
The liftgate emblem
*
The liftgate name plates
2. Apply masking tape (1) to the body side border of the emblem or the nameplate to protect the body from scratches. The tape will also aid in
aligning the emblem or nameplates during installation.
Important: Do not overheat the component.
3. Using an auxiliary heat source, heat the molding, the emblem or the nameplate to between 40-60°C (104-140°F).
4. Use J 41409 or the equivalent in order to cut through the adhesive material.
5. Remove the emblem or the nameplate from the vehicle.
Installation Procedure
Important: Apply the adhesive tape in an environment free of dust or dirt so that it does not come in contact with the sticky backing and
prevent proper adhesion.
