Vibe FWD L4-1.8L (2010)
4. Separate the indicated bracket.
5. Open the clamp, slide the hose about 1 to 2 ribs towards the left side of the vehicle and close the clamp.
6. Reconnect the bracket to the intake manifold, check; check the spacing.
11. Install the No. 1 fuel vapor feed hose.
1. Install the NEW No. 1 fuel vapor feed hose to the air tube so that its yellow paint mark (1) faces outward.
2. Install the NEW No. 1 fuel vapor feed hose to the intake air connector so that its white paint mark (2) faces front.
12. Install the No.1 air cleaner hose.
1. Install the No.1 air cleaner hose with the two hose clamps (1).
2. Connect the ventilation hose with the clip (2).
13. Verify installation.
Check the installation of all parts that were replaced or removed and then reinstalled.
