Vibe FWD L4-1.8L (2010)
49. Route the deployment harness out of the driver side of the vehicle.
50. Disconnect the IPM yellow harness connector (1) from the vehicle harness connector.
Note: If vehicle is equipped with dual stage air bags the IPM will each have 4 wires. Refer to Component Connector End Views (See:
Diagrams/Connector Views) for determining high and low circuits.
51. Cut the yellow harness connector out of the vehicle, leaving at least 16 cm (6 in) of wire at the connector.
52. Strip 13 mm (0.5 in) of insulation from each of the connector wire leads.