Vibe FWD L4-1.8L VIN 8 (2004)
Trunk / Liftgate Shock / Support: Service and Repair
Strut Replacement - Liftgate Window
Strut Replacement - Lift Gate Window
Removal Procedure
Caution: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or
personal injury.
1. Open and support the liftgate window.
2. Lift up the retainer clips on the assist rods using a small flat-bladed tool.
3. Remove the upper end of the assist rods from the ball joint.
4. Remove the lower end of the assist rods from the ball joint.
5. Remove the assist rods from the liftgate window.
Installation Procedure
1. Position the assist rods to the liftgate window.
2. Install the upper end of the assist rods to the ball joint. Press in to place until fully seated.