Vibe FWD L4-1.8L VIN 8 (2004)
4. Apply tape to the location as shown (1).
5. Heat the mounting surface to approximately 27-41°C (80-105°F).
6. Ensure that the temperature of the molding is approximately 29-32°C (85-90°F).
Important: Do not touch the adhesive backing on the molding.
7. Remove the protective liner from the back of the molding.
8. Position the molding to the location marks and press the molding to the mounting surface.
9. Apply equal pressure along the molding to uniformly bond the item to the mounting surface.
10. Remove the protective tape from the mounting surface.
