Vibe FWD L4-1.8L VIN 8 (2004)
Installation Procedure
1. Install the rear body side lower garnish molding (1) to the vehicle. Ensure that the plastic retainers are fully seated.
2. Install the rear seat hinge (3) to the rear body side lower garnish molding (1).
Notice: Refer to Fastener Notice in Cautions and Notices.
3. Install the bolt (2) to the rear seat hinge (3).
Tighten the rear seat hinge bolt to 18 N.m (13 lb ft).
4. Install the rear seat assembly. Refer to Seat Replacement - Rear (See: Seats/Service and Repair/Seat Replacement - Rear) in Seats.
Garnish Molding Replacement - Windshield Pillar
Garnish Molding Replacement - Windshield Pillar
Removal Procedure
Gently pry and remove the windshield side garnish molding (1) from the vehicle.
Installation Procedure
Install the windshield side garnish molding (1) to the vehicle. Ensure that the plastic retainers are fully engaged.
Trim Panel Replacement - Lower Center Pillar
Trim Panel Replacement - Lower Center Pillar
Removal Procedure
