Vibe FWD L4-1.8L VIN 8 (2004)
in the pedal.
8. Install the push rod clevis pin and the washer in order to retain the push rod clevis to the pedal.
9. Install the clip (7) in order to retain the clevis pin to the pedal.
10. Connect the stoplamp switch connector.
11. Connect the negative battery cable.
12. Measure the brake pedal travel. Adjust if necessary. Refer to Brake Pedal Travel Measurement and Inspection. See: Hydraulic System/Testing and
Inspection/Component Tests and General Diagnostics/Brake Pedal Travel - Measurement & Inspection
