Vibe FWD L4-1.8L VIN 8 (2004)
34. Replace the CMP actuator if the following conditions exist:
^
CMP actuator does not lock with air pressure removed.
^
CMP actuator does not unlock with air pressure applied.
^
CMP actuator does not rotate smoothly through the advanced positions.
^
CMP actuator does not rotate completely through the advance positions.
35. Install the front camshaft bearing cap.
Notice: Refer to Fastener Notice in Service Precautions.
36. Install the front camshaft bearing cap bolts.
^
Tighten the camshaft bearing cap bolts to 23 Nm (17 ft. lbs.).
Installation Procedure
1. Use a wrench in order to align the camshaft timing marks. Be sure to place the wrench on the hexagonal portion of the camshafts.
2. Turn the camshafts in order to align the timing marks.
