Vibe FWD L4-1.8L VIN 8 (2004)
Air Door Cable: Service and Repair
Mode Control Cable Replacement
MODE CONTROL CABLE REPLACEMENT
REMOVAL PROCEDURE
1. Remove the radio.
2. Remove the center knob from the HVAC control unit.
3. Remove the screw from the control unit.
4. Remove the center console and heater control trim panel (1).
IMPORTANT: Note the routing of the cable to make installation easier.
5. Disconnect the mode control cable from the HVAC control unit.
6. Disconnect the mode control cable from the HVAC module assembly.
7. Remove the mode control cable from the vehicle.
INSTALLATION PROCEDURE