Vibe FWD L4-1.8L VIN 8 (2004)
Mass Air Flow (MAF) Sensor: Service and Repair
MASS AIR FLOW (MAF) SENSOR REPLACEMENT
REMOVAL PROCEDURE
1. Disconnect the electrical connector (1) from the mass air flow (MAF) sensor (4).
2. Remove the two fasteners.
3. Remove the MAF sensor (4) from the air cleaner housing (2).
4. Remove the O-ring (3).
INSTALLATION PROCEDURE
1. Install a new O-ring (3) on the MAF sensor.
2. Install the MAF sensor (4) into the air cleaner housing (2).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Secure the MAF sensor to the air cleaner housing with the 2 fasteners.
Tighten
Tighten the 2 fasteners to 2 N.m (18 lb in).
4. Connect the MAF sensor electrical connector (1).