Vibe FWD L4-1.8L VIN 8 (2004)
Tighten the manual lever nut to 12.5 Nm (9 ft. lbs.).
10. Install the PNP switch electrical connector to the PNP switch.
11. Install the shift select cable and nut to the manual lever.
Tighten the shift cable retaining nut to 12.5 Nm (9 ft. lbs.).
12. Install the shift select cable (1) in the retaining bracket, then install the clip (3).
13. Install the battery tray in the vehicle, then the 4 battery tray retaining bolts.
Tighten the bolts to 13 Nm (10 ft. lbs.).
Caution: Refer to Battery Disconnect Caution in Service Precautions.
Install the battery.
14. Apply the parking brake and block the vehicle wheels.
15. With the manual selector in Park position, turn the ignition switch to START and verify that the starter motor operates.
16. Stop the engine and return the ignition switch to the ON position.
17. Move the manual selector from the Park position to the Neutral position and verify that the starter motor operates.
18. Verify that the starter motor DOES NOT operate in D, 2, L or R.
