Vibe FWD L4-1.8L VIN 8 (2004)
8. Disconnect the four electrical connectors (1) from the fuel injectors.
9. Release the three clamps (2) from the fuel Injector wire harness.
10. Lift the fuel Injector wire harness up and away from the fuel rail.
11. Remove the fastener (2) from the fuel pipe bracket.
12. Remove the fasteners (1) from the fuel rail (7).
13. Remove the fuel rail (7) and the spacers (3) from the engine.
14. Remove the fuel injectors (5) with the O-rings (6) and with the grommets (4).
Installation Procedures
1. Install new O-rings (6) and new grommets (4) on the fuel injectors (5).
2. Apply clean engine oil to the O-rings (6) and to the grommets (4).
3. Install the fuel injectors (5) into the fuel rail.
4. Install the fuel rail (7) and the spacers (3) onto the engine.
Notice: Refer to Fastener Notice .
5. Secure the fuel rail to the engine with the 2 fasteners (1).
Tighten the fasteners to 19 Nm (13 lb ft).
6. Install the fastener (2) to the fuel pipe bracket.
Tighten the fastener to 9 Nm (80 lb in).
